Die Lock Ring Zinc (qty 5) w/ Die Wrench

$21.00
In stock
SKU
10668
A characteristic of virtually all progressive reloading machines, regardless of brand, is that the dies are set rather close together. When you are first setting up a "naked" machine, there is plenty of wrench room, but if you have a need to adjust a die afterward, it often requires a delicate touch to maneuver a lock ring on a crowded toolhead.
Dillon Precision has addressed this in two ways. We now offer new 1" cast zinc die lock rings and a 1" Bench Wrench to fit them. This combination gives much more room to re-adjust dies after they're already mounted. The opposite end of our new wrench is a 7/16" box-end for adjusting the Powder Bar of any Dillon Powder Measure. Our new lock rings fit any standard 7/8" x 14 dies.

    WARNING: This product can expose you to chemicals including lead, which are known to the State of California to cause cancer and reproductive harm. For more information, go to https://www.P65Warnings.ca.gov

Dillon Precision Products, Inc. © 2022 | All Rights Reserved | 8009 East Dillons Way Scottsdale, AZ 85260 | 800-223-4570