Don't forget to get your 2025 Calendars! Click here to buy now!

Burstfire 2-in1 Brass Case Annealing Machine and Case Prep Center

Introducing an industry first: the original Burstfire 2-in-1 Brass Case Annealing Machine and Case Prep Center! Now you can improve and Automate the process of brass-case annealing and increase the speed and accuracy of case prepping for reloading! GEN 2 Brass Case Annealer features:

• Red Anodized Aluminum Wheels (Standard, Magnum, and Bottom Rotation Wheel) 

• Tool-less Adjustment 360 Swivel Torch Holder. The only tool-less torch holder design on the market! Now standard on all Gen 2 units

• Sleek, glossy glass digital display for speed Controller. 

• Improved/Updated speed control to a sleek and silky smooth turn knob design. Provides both speed, and simplified speed change operation.

• Updated chute design. Improved feeding when processing large batches/full chute.

• No complicated set up required! Simply attach the torch to the torch holder, and ready to go in 15 seconds! No messing around with finicky set ups like other units out there.

• Powered by six independently driven high torque motors. Unlike all other annealers, it has no plastic parts, and is not gear driven. Each motor is rated for 30k+ hours. No single point of failure! 

• Precision Laser cut steel panels with a beautiful, durable, wear- and scratch-resistant finish. 

• Brass case capacity is approximately 200-300 cases (dependent on caliber).

• Mechanically operated case release/drop, eliminating the need to adjust/tune it based on case size.

• Aluminum Standard wheels will accommodate cases from .300 BLK, 6BR, .223, and up to .30-06.

• Aluminum Magnum wheels will accommodate cases up to .338 Lapua or similar cases.

• Short case feed ramp – for annealing short cases such as 6BR/.300 BLK/pistol cases – included. 

No complicated assembly, finicky set up/adjustments needed out of box! Open the box, attach the torch to the ring, and you’re ready to go!

Case Prep Center

The Case Prep Center is powered by four independently operated high torque motorized heads on the top. It will accept any industry standard 8/32 thread attachments for deburring, chamfering, primer pocket reaming, pocket uniforming, flash hole uniforming, etc. Case Prep Center Attachments are sold separately, if you do not have them already. 

One of four motors operates at reduced speed, to allow for precision work normally done by hand.

The Case Prep center can be operated upright, or laid down on the steel handle, to maximize comfort, based on your personal preference. 

The On/Off switch is independent from Case Annealer. 

Features a steel handle for easy carrying.

$290.00
In stock
Low Stock: Only 4 Remaining
SKU
14650

    WARNING: This product can expose you to chemicals including lead, which are known to the State of California to cause cancer and reproductive harm. For more information, go to https://www.P65Warnings.ca.gov

Items of Interest
Dillon Precision Products, Inc. © 2025 | All Rights Reserved | 8009 East Dillons Way Scottsdale, AZ 85260 | 800-223-4570