RescueRandyMD
RescueRandyMD
2 posts
Joined December 2017

XL650 Powder Measure Leak

So I just got a XL650 and first session went well for 9mm using Titegroup. However, I had good amount of powder leak between the small powder bar and spacer.

Going through the forum I saw comments on adding springs from the old powder measure doing a retromod or scotch tape for shims. If I were to add the springs it would be to lessen the charging impulse and not replace the failsafe rod. Can anyone offer any insight into what I should do to solve my problem?
dillon
Administrator
dillon
2,820 posts
Joined July 2007

RE: XL650 Powder Measure Leak

Adding springs will not decrease powder leakage from between the bar and spacer. We have a slightly thicker spacer bar we can send to you. Please phone us, or email us and request one. If you email us, please include your address.
RescueRandyMD
RescueRandyMD
2 posts
Joined December 2017

RE: XL650 Powder Measure Leak

Thanks! You guys are great
Fishobaby
Fishobaby
8 posts
Joined December 2017

RE: XL650 Powder Measure Leak

Yeah, I really watch a lot of YouTube...

https://www.youtube.com/watch?v=KpGZArdOp5k

Pretty helpful video. The voice reminds me of the educational videos (propaganda?) they used to show us in school. Fortunately, the video quality is much better!