Slip 2000 Copper Cutter, 4 oz
Click to zoom

Slip 2000 Copper Cutter, 4 oz

Stock Number: 11646

Copper Cutter is specially formulated to remove: copper, lead, powder residue and plastic wad fouling from bore surface with very little scrubbing!

Cleans bores in:

  • Rifles
  • Shotguns
  • Pistols
  • Revolvers
Directions
  • Keep the muzzle end pointed down to prevent cleaner from running back into the actions or chambers
  • Soak a patch, brush or mop with Copper Cutter and run through bore. Follow this with a dry patch
  • Repeat until dry patch come out clean
  • After patch comes out clean, it is very important to run a mop or patch with a lubricant on it to completely recoat bores with lubricant protection
Always Relubricate After Cleaning
Copper Cutter is a Water Based - Ammonia Enhanced product and it will remove all lubrication or oil protection. Care should be taken to re-lube all parts cleaned with Copper Cutter to prevent rusting and corrosion. Always follow up with a lubricant to displace any moisture left behind from cleaning. This will not only protect your weapon but it will reduce your next cleanup time.

DANGER:
Harmful or fatal if swallowed. Contains ammonia. Use in well-ventilated area. Avoid prolonged contact with eyes. If swallowed, call physician immediatly. Do not induce vomiting. Keep out of reach of children. May be harmful to some materials. Always be sure to wipe stock and nickle surfaces dry after cleaning.

Products sold on this page are known to the state of California to cause cancer, birth defects or other reproductive harm
QTY:  
$11.99