Zecura
Zecura
1 post
Joined May 2013

RL 1050 case feeder tube

Just got my RL1050 back from a factory overhaul. Loaded a few thousand 223s and now I have switched to my 9mm tool head. Got everything back together but now my case feed tube is an inch and a half too short from fitting into the case feeder mechanism. I'm scratching my head trying to figure out how it worked with the 223. My old case feeder tube was a nice tight fit from the case sorter to the case feeder. Is there a length difference between the RL1050 case feeder tubes and the Super 1050 case feeder tubes?
dillon
Administrator
dillon
3,043 posts
Joined July 2007

RE: RL 1050 case feeder tube

It sounds like the plastic case feed bowl is not bottomed out onto the post. Be sure no flashing is interfering with the bowl seating properly.