clange
clange
7 posts
Joined April 2016

Resizing Die

Hello, I was processing military brass and I bent the depriming rod on the .223 carbide resizing/decapping die. What is the part number I need to order to replace it? The pictures on the webpage and what I have seem different. I'm running the Super 1050. Thank you.

Charles
divejj
divejj
110 posts
Joined December 2012

RE: Resizing Die

Where is it bent? If its on the lower part only, you just need the pin #13278. if it was further up, the bolt section is #13182. FYI, the expander ball is #13269. Purchase a few extras if you're loading a lot, especially mixed brass. There have been times that I have bent either or both. It's a fast replace if you have the whole assembly together.
clange
clange
7 posts
Joined April 2016

RE: Resizing Die

It was the lower part. Thank you very much. I'll get some spares so I'm not knocked out of service too long.