dm00246
dm00246
11 posts
Joined January 2013

Primer Feed Problem

New to the Super 1050. I had a primer stuck and had to remove primer tube assy to clear, no problem. Now I cannot get the primer tube to line up and feed smoothly, you have to put a lite touch of pressure on plastic rod. Have removed several times, tube polish out and plastic collar clean. Primers slide smoothly, hundred on floor for proof of that. I have removed, loosen, wiggled around and sometimes it will feed a few but only half the time or less. I have loaded hundreds of thousands on my 650 and never had this problem. This loader belongs to a friend. Any ideas? Brass rod with lead weight on top?
dillon
Administrator
dillon
2,863 posts
Joined July 2007

RE: Primer Feed Problem

There is a ridge on one side of the plastic primer magazine tip. When you insert the tube, slide it all the way down. Now rotate the tube so the ridge lines up with the corresponding groove, and it will drop down a bit further.