mrocque
mrocque
1 post
Joined November 2016

Primer Arm not fully extending

This is a new Super1050 for my 38 SuperComp. When I set up the primer arm, it worked fine with 100+ "dry runs" while adjusting and measuring lengths etc... Then I added primers, and the primer plate will not advance forward without assistance (about 1/4" short of full forward). I have readjusted several times and it just will not advance foreword to allow the press to complete the cycle.
Any advise would be greatly appreciated.
Thanks
dillon
Administrator
dillon
2,923 posts
Joined July 2007

RE: Primer Arm not fully extending

It sounds like primer primer arm assembly is either not down quite far enough, or the primer feed body is bolted on backwards. The base of the primer feed body has a shallow vertical groove , which needs to be oriented rearwards.
Beyond that, please phone us when you can be in front of the machine.