Keasbeynights
Keasbeynights
1 post
Joined May 2019

Powder die/measure setup issue

Setting up my new 550C for 9mm. Followed instructions on setting up the powder die/funnel/measure.

It seems I cannot adjust for enough case mouth flare. When it's setup to where the charge bar has full travel, but i get little to no case mouth flare.

When i just for enough case mouth flare, the linkage travels too far and the square bushing pops out.

What am I missing, or doing wrong?
dillon
Administrator
dillon
3,222 posts
Joined July 2007

RE: Powder die/measure setup issue

You probably need to snug the nylock nut on the bellcrank bolt another 1/2 turn or so. This will prevent the bellcrank cube from popping out of the notch.
jimmyguitar
jimmyguitar
4 posts
Joined May 2019

RE: Powder die/measure setup issue

same thing here... still isn't working
dillon
Administrator
dillon
3,222 posts
Joined July 2007

RE: Powder die/measure setup issue

Check the powder funnel and compare it to the manual, to ensure the correct powder funnel is being used. Beyond that, please email us some photos to sales@dillonprecision.com , send as a jpeg or pdf attachment.