venti30
venti30
5 posts
Joined December 2017

Part #20341

I ordered the screwdriver, 20341 to investigate why my primer punch wasn’t sitting flush, and have found that it doesn’t fit the retainer on my RL 1050. Are the slots cut into the primer punch hold down screw thicker on a super, than on an RL? The screwdriver blade is too thick to fit my RL.
dillon
Administrator
dillon
3,067 posts
Joined July 2007

RE: Part #20341

There is no dimensional difference in the slot width, other than tolerances. Measure the screwdriver width and the slot width using calipers. It is probably just a few thousanths.
78Staff
78Staff
5 posts
Joined January 2016

RE: Part #20341

Mine didn't fit the Super 1050 for that matter - apparently just a tolerance/QC at whoever is making these for Dillon. Had to knock a bit off to allow it to fit.