Setting up the RT1200, RT1200B or RT1500

Oct 3rd, 2016
To setup either the RT1200, RT1200B or the RT1500 follow these steps:
  • Adjust the trim die exactly as you would a sizing die, to size to minimum headspace. Use of a headspace cases gage is recommended.
  • Lube a piece of brass, run it up into the die and leave it there.
  • Now thread the motor onto the top of the die until the cutter contacts the top of the case. Lock it down using the jam nuts, trim a cases and test.
  • Fine tune by threading the die up or down as needed.

If you need further assistance please call us at 800-762-3845.  Please be in front of your machine when you call.

We have several helpful videos on our site.  Just scroll down until you find the one you need.


Follow us on Facebook.
Thank you for your feedback!

Send Us Your Feedback

  • Required fields are indicated by an asterisk (*)

Related Articles

  • No related articles were found.
Phone Support
Phone Support
Toll Free 800-762-3845
Local 480-948-8009
Email Us
Email Us
Have questions?
Send us a message!
Ask Community
Ask Community
Our forum is a great place to get help from our community of users and customers.