zamble
zamble
1 post
Joined December 2012

Die Lock Rings

I have a 1050 and I am looking for some die lock rings.  I have 3 tool heads.  One set up in 9mm, one in .223 and the third setup to process brass in .223.  I want to add .308 to set up, but I don't want to pay a fortune for the 2 extra tool heads right now.

I want the die lock rings to swap out on the 2 .223 tool heads I have, trimming and reloading.  I just want to be able to set the dies and lock them in, so I can switch calibers without the hassle of fine tuning them all the time.  Can any one recommend some good lock dies that will fit in the 1050?

 

Thanks

Henny
Henny
5 posts
Joined February 2011

RE: Die Lock Rings

I pretty much use Dillon everything except die rings. The Hornady locking rings are about the best ones out there.
Rickpowell_1955@hotmail.com
Rickpowell_1955@h...
1 post
Joined December 2014

RE: Die Lock Rings

RCBS also makes good lock rings. They have an allenhead set screw.
RoyD
RoyD
4 posts
Joined August 2016

RE: Die Lock Rings

I use the Forster cross bolt lock rings. They loosen and adjust easily. Cheaper by the ten pack, often cheap on Ebay.