jboss236@gmail.com
jboss236@gmail.co...
3 posts
Joined May 2020

Cases misaligned in stations 1 and 2

Hello,
The 9mm brass in station 1 of my 550c keeps hitting the bottom of the die when I press/raise. It leans out/away from the shell plate causes the misalignment. The spring is just contacting the bottom of the brass and I’ve pressed about 4K rounds through it already with no issues. The same issue tends to happen in station 2. Any suggestions?

Thanks
Jeff
jboss236@gmail.com
jboss236@gmail.co...
3 posts
Joined May 2020

RE: Cases misaligned in stations 1 and 2

Nevermind, it was the shellplate that needed tightening.