asandoval
asandoval
1 post
Joined July 2014

Case feeder misaligned?

I need your help guys, recently I bought an RL 1050 from a friend, he does not gave me the case feeder so I tried to install the case feeder from my XL650, as I undestand that the casefeeders can be interchangeable between the 650 and 1050/Super 1050 since the plastic bowl is molded to fit over both the square and round posts.

But for some reason after mounted it on RL1050 Squared post It is not aligned with the case feeder tube, is slightly turned to the left.

Here a link to a picture I took:

http://i40.photobucket.com/albums/e207/aasp76/case%20feeder%20misaligned_zpsypsrki7i.jpeg

Any idea ?
dillon
Administrator
dillon
3,111 posts
Joined July 2007

RE: Case feeder misaligned?

No photo in that location
Normhays
Normhays
5 posts
Joined November 2016

RE: Case feeder misaligned?

I have a new Super 1050 I got earlier this year and have noticed the same issue. The case feed system is not in line. Seems like the case feeder is turned a few degrees toward the front, but its rigid mounted to the tube and frame. I'd post a picture but this platform does not seem to allow that.
divejj
divejj
137 posts
Joined December 2012

RE: Case feeder misaligned?

Dillon,
I cut and pasted the picture and I see it. I don't have a solution to asandoval's issue, but did verify that both the 650 and 1050 bowl's have the same part #.
Humbo
Humbo
1 post
Joined February 2015

RE: Case feeder misaligned?

There are two sets of holes in the 1050 frame, with new casefeeders you'll need to use the rear holes. With older casefeeders you might need to use the front holes.