mneblett
mneblett
19 posts
Joined October 2010

Case Feeder .223 cases inside down

I used my new case feeder for the first time with the small rifle plate and .223 Remington brass (XL650, but I believe that's irrelevant).

About 1 out of 10 cases is feeding upside down. I reviewed the past 10 pages of Q&A in this forum, and didn't see anything on point.

Suggestions? Some adjustment I'm missing?

Thanks,
Mark
dillon
Administrator
dillon
3,074 posts
Joined July 2007

RE: Case Feeder .223 cases inside down

It sounds like the sheet-metal cuff that is pressed over the left side of the square opening in the bowl where cases come out is bad. See if the inside of this cuff actually contacts the plastic bowl, or if it stands away from it by about 1/8-3/16 of an inch. If so, email us and include your address so we can mail a replacement cuff to you.
mneblett
mneblett
19 posts
Joined October 2010

RE: Case Feeder .223 cases inside down

Thanks -- I'll take a look at that when I get home tonight.
mneblett
mneblett
19 posts
Joined October 2010

RE: Case Feeder .223 cases inside down

A follow-up: I moved the metal plate to the right ~1/4", and all cases are falling correctly. Thanks for the help!