Sweeper13
Sweeper13
10 posts
Joined January 2017

Brass moving back when depriming.

Hi...

When I put a clean piece of brass in the first stage to deprime, the brass moves back out and hits the die when going up.I have to use my finger to push the brass in the shell plate. Then it will go up to deprime. It doesn't happen all the time, but way more after installing my replacement handle a few weeks ago. Let me know if there is anything I can fix on my side.

Thanks
Sweeper13
Sweeper13
10 posts
Joined January 2017

RE: Brass moving back when depriming.

I also wanted to add. The shell plate was replaced in 5-7-14 aprox: 17k rnds since then.
Sweeper13
Sweeper13
10 posts
Joined January 2017

RE: Brass moving back when depriming.

Cancel...The press wasn't level, of course it was leaning more toward the handle.