cervri
cervri
15 posts
Joined October 2016

38 Spcl Problems

Firs off, I have loaded many 38 spcl and had no problems. Today I had problems that I hate to admit....Set my powder measure and got my bell just right. Bullet just fits. I measure the bell and all, don't remember the measurement now unfortunately, anyway on to the seating die. This is where I ran into the problems. I did not want to crimp with the die so had it backed out a bit so that it would not crimp. Ran a case in it and it straightened my bell. I was not able to get a case even started into the die without losing my bell..I feel like a complete idiot, I know I am doing something wrong, but my mind is a blank. Any help appreciated....
cervri
cervri
15 posts
Joined October 2016

RE: 38 Spcl Problems

Never mind, got my head screwed on right this morning. Done deal...
cervri
cervri
15 posts
Joined October 2016

RE: 38 Spcl Problems

Never mind, got my head screwed on right this morning, done deal.
kughn@peak.org
kughn@peak.org
2 posts
Joined February 2020

RE: 38 Spcl Problems

Any help? Case feeder is not fully indexing and allowing the casing to not drop to the shell plate????