Print This Page
I bought lee cast bullet sizing dies. What do I need to mount the ram to the sheel plate.
Im guessing on a lee press this ram fits directly on the machine where normally a case adapter would go.
Login to reply to this topic
|
Posted by: dillon
Posted on: 2009-11-02 at 07:14:31 AM
|
This unit requires a smaller diameter shaft cut for a lee type shellholder to push the bullet up through the lube/size die. No adapter available.
|
Posted by: anm2_man
Posted on: 2009-12-16 at 02:50:55 PM
|
You need to look at a in-expensive LEE single stage press. I bought one for Midway for just that purpose. It was really cheap <$30 and it works for both resizing projectiles and de-milling reloaded rounds that I screwed up (but not too many of those). Dillon Rocks !
