case trimmer & XL650

By tfowler
Published on: 2007-12-16 at 1:26 PM

Replies: 0

Hello I'm new into relaoding I got my 650 last year. I've loaded alot of .40 cal w/it. Just got an ar 15 I'm going to start loading 223. My question is will the1200B fit in my loading set up or will i have to run it separate?

Click here to view more topics by tfowler

Login to reply to this topic

Posted by: dillon

Posted on: 2007-12-17 at 09:57:39 AM

You can use the trimmer on the XL650, but you cannot trim and reload at the same time. Suggest you set up the trimmer on a separate toolhead.

Posted by: tfowler

Posted on: 2007-12-17 at 11:27:28 AM

that's what i thought just looking at the picture (wishful thinking) thank you for your quick response ps love my loader!

Posted by: cmbishop

Posted on: 2008-01-20 at 08:38:35 AM

Recently purchased a XL650 with trimmer. My first time using the trimmer the motor became very hot within a short time period. Is this normal? I processed 75 cases of 223 cal. Is this a break-in period for the motor? (Brushes)

I ran the motor once again after cooling and it DID NOT get hot. I disconnect the vacuum from the trimmer this time and not on the first run.

Also there is alot of noise (vibration) created from the motor and the tool die being loose within the XL650. Is there a method for eliminating this noise?

Your thoughts?

Thank you,

Posted by: dillon

Posted on: 2008-01-22 at 02:27:57 PM

The trimmer runs very hot! The motor is DC, with a bridge rectifier in the control box to convert the AC to DC. This motor, like all DC motors, runs hot enough to brew a pot of coffee on.

No way to eliminate the noise you are referring to.

Forum

case trimmer & XL650

Login to reply to this topic

Thank you,