I have noticed that when I empty my power back into the power can that static holds some of the power in the power measure. I was told to use dryer sheets and rub the measure to remove the static. This did some good.

I have found that if you ground your press and bond your power measure that this will remove the static. Use a bonding strap from the press to the measure when puting the power back into the container. Make the strap about three feet long. If you have carpet on the floor, Place a antistatic pad in front of your press. This can be found at your local computer store. My fear as been that a spark near the power measure could happen. To my knowledge this has never happened.

Keep on loading..............................DAVE######################