Greatings to all

While loading 45/38/357 I have found the cartridge does not line up with the sizer. In order to line up with the die I pull the top of the cartridge on the direction of the center of the shell plate, this issue occures more often then not. I have:

1. Made sure the ejector wire is not touching the shell plate.

2. Installed the shell plate just loose enough to rotate.

3. Inserted a shell case in the die before tightening the lock ring.

4. Adjusted and readjusted the Case insert slide and slide cam.

And I qualifed under Title 18 USC @926 (C) (a) :)

 

Thanks