Login
Print This Page
View Cart
and then when i look at the primer pusher, there is a little metal shaving (im guessing its shaving a little of the primer off)
any way to remedy this problem?
Indentions in new primers...
|
By justinbaker
Published on: 2008-05-29 at 2:58 PM |
Replies: 0
|
so it seems for some reason now after every 10-20 rounds, i am getting this indention into my primers as i load
and then when i look at the primer pusher, there is a little metal shaving (im guessing its shaving a little of the primer off)
any way to remedy this problem?
and then when i look at the primer pusher, there is a little metal shaving (im guessing its shaving a little of the primer off)
any way to remedy this problem?
Login to reply to this topic
|
Posted by: dillon
Posted on: 2008-05-30 at 08:46:04 AM
|
This is indeed shavings from the edge of the primer cup, being clipped off while they are seated. Make sure the shellplate is snug-push down on the edge of the shellplate between stations 2 and 3. If it feels springy, then snug the shellplate bolt a little. Also, adjust the bent-paperclip lookin' wire to almost(but not quite)touch the rim of the case. It should be within .002"-.006" of touching, about the thickness of a piece of paper.
